If unable to move the door and suspect beam is faulty, enter Safety Beam Emergency Close by pressing and holding a pre-coded button on the transmitter for more than five seconds and the door will start closing. Remedy 1 Normal operation (door is fully open) 2 PE is preventing the door from moving Clear away any obstructions. The below table identifies the issues and remedies. Requirements for a service and user warnings are indicated after operation by the main light repeatable flashing OFF a number of times followed by a pause. Main Light = Service / Warning Indicator:

Upon completion, refit the controls cover and test the opener operation through the Dominator App.

Follow on-screen instructions in the Dominator App.

Go to phone settings, then WiFi, and select (DOM000000).

The NETWORK indicator will turn purple when Hot Spot is Active.

Press and hold the OPEN button on the opener for 4 seconds.

On the opener press the MODE button repetitively until the NETWORK Indicator is lit.

Ensure the WiFi router is within range of the opener.

Remove the controls cover on the opener to access the buttons.

The initial setup involves linking your phone app and smart opener to your home network. The Smart Phone Control works via your home’s WiFi network.

Use a non-metallic object to push the battery down through the side opening to remove the battery.

Use fingernails to separate the remote casing to expose the circuit board.

Light Status Battery Status Solid OK Flashing Replace No light Replace Check the Light Status table to determine if the battery needs replacing.

To test the battery is working, press and hold a remote button.

Main Light Remote Status ON Button added OFF Button removed 2 flashes, then OFF Remote control deleted 4 flashes, then OFF Memory full The remote button is now coded, press to test.

Press the remote control button again until the main light stops flashing rapidly.

Press one of the four (4) buttons on the transmitter until the main light starts to flash rapidly, then release the transmitter button.

The Main light will start to flash rapidly.

Press and HOLD the CLOSE button to set the Open/Stop/Close function.

Press the MODE button repetitively until the REMOTE INDICATOR is lit.

Remove the controls cover to access the buttons.

Dominator garage door opener manual